Table of Contents
Advertisement
2.
Remove the battery (2).
Reverse this procedure to install the battery.
Solid-state drive
Description
512-MB, M2.2280, SATA-3, solid-state drive supporting TLC
256-MB, M2.2280, SATA-3, solid-state drive supporting TLC
256-MB, M2.2280, PCIe-2×4, solid-state drive
128-MB, M2.2280, SATA-3, solid-state drive supporting TLC
128-MB, M2.2280, SATA-3, MH solid-state drive
Before removing the solid-state drive, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the display panel assembly (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×2.5 screw (1) that secures the solid-state drive to the slate. (The solid-state
drive tilts up.)
24
Chapter 5 Removal and replacement procedures
Display panel assembly on page
Spare part number
763008-006
760615-014
814693-001
759848-011
827560-008
20).
Hide quick links:
Advertisement
Table of Contents
