Table of Contents
Advertisement
Rear-facing webcam
Description
Rear-facing webcam (includes cable and double-sided adhesive)
Before removing the front-facing webcam, follow these steps:
1.
Turn off the slate. If you are unsure whether the slate is off or in Hibernation, turn the slate on, and then
shut it down through the operating system.
2.
Disconnect the power from the slate by unplugging the power cord from the slate.
3.
Disconnect all external devices from the slate.
4.
Remove the display panel assembly (see
Remove the rear-facing webcam:
1.
Release the ZIF connector (1) to which the rear-facing webcam cable is attached, and then disconnect
the rear-facing webcam cable from the system board.
2.
Detach the rear-facing webcam (2) from the back cover. (The rear-facing webcam is attached to
the back cover with double-sided adhesive.)
3.
Remove the rear-facing webcam and cable.
Reverse this procedure to install the rear-facing webcam.
Display panel assembly on page
Component replacement procedures
Spare part number
830349-001
20).
33
Hide quick links:
Advertisement
Table of Contents
