MAINTENANCE WORK ON FRAME AND ENGINE
Removing the seat
9.49
Fitting the seat
9.50
–
Mount the dust cap.
Info
The rubber seal in the dust cap prevents air leaking out of the tire if the valve is
defective.
–
Insert the ignition key in the seat lock
–
Raise the rear of the seat, push it towards the rear, and remove it upwards.
100669-10
–
Position the recesses of the seat to the lugs on the frame, lower the rear end and simul-
taneously push it forward.
–
Lock the seat by turning the ignition key in the seat lock.
–
Remove the ignition key from the seat lock.
–
Finally, check that the seat is correctly mounted.
100730-10
and turn it clockwise.
153