Table of Contents
Advertisement
MAINTENANCE WORK ON FRAME AND ENGINE
–
Remove spacer
seal rings.
Long-life grease (
–
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
–
Replace the wheel bearing.
–
Install the spacer.
–
Clean the thread of the axle and nut.
100724-10
–
Clean the mating surfaces of the brake caliper frame and swingarm.
–
Push the brake caliper frame
–
Position the rear wheel, and place the brake caliper frame between the rim and the
brake disc.
–
Slide the brake caliper onto the brake disc.
–
Position the rear wheel on the mating surfaces in the swingarm.
100725-10
. Clean and grease the mating surfaces of the spacers and the shaft
p. 239)
x
completely to the rear.
148
Advertisement
Table of Contents
