Radio Setup - GREAT PLANES FlatOuts Extra 300S ARF Instruction Manual

❏
2. Slide the wheels onto the axles, and secure them with
a D6 wheel collar. The flat side of the wheel collar should
be toward the wheel. Secure the wheel collar with a drop of
glue in the teeth opposite the wheels.
❏
3. Make two wheel pants by gluing the inner and outer
wheel pant parts together. Be sure to make a right and a
left. Glue the inside of both wheel pants to the wheel collars.
❏
4. Snap the D5 tailwheel into the D4 tailwheel bracket.
❏
5. Slide the tailwheel bracket over the rudder and rudder
post. Glue the bracket to the rudder and not to the rudder
post . The bracket needs to pivot on the rudder post.

Radio Setup

❏
1. Glue the elevator servo into the front servo mount in the
left side of the fuselage. The output shaft should be forward.
❏
2. Glue the rudder servo into the rear servo mount in the
right side of the fuselage. The output shaft should be forward.
❏
3. Refer to the parts list in the front of the manual and
select the correct double-sided servo arm for the aileron
servo you will be using. There are three arms to choose from:
Servo arm A Hitec HS-55, Hitec HS-50, Futaba 3108M
Servo arm B Futaba S3103, Airtronics 94091
Servo arm C JR 241
❏
4. Connect two A1 Z-bend clevises to the outer holes of
the servo arm you have selected.
13