Finish The Landing Gear; Radio Setup - GREAT PLANES FlatOut Flatana Instruction Manual

Finish the Landing Gear

❏
1. Install a 2 x 17mm [5/64" x 21/32"] axle and axle
support (D1) onto each landing gear leg. Make sure that
the axles are perpendicular to the centerline.
❏
2. Slide the wheels onto the axles, and secure them with a
wheel collar (D6). The flat side of the wheel collar should be
toward the wheel. Secure the wheel collar with a drop of glue
in the teeth opposite the wheels. Align the wheels with the
centerline and secure the axles and supports with a drop of
glue through the holes in both sides of the axle supports.
❏
3. Make two wheel pants by gluing the inner and outer
wheel pant parts together. Be sure to make a right and a
left. Glue the inside of both wheel pants to the wheel collars.
❏
4. Snap the tailwheel (D5) into the tailwheel bracket (D4).
❏
5. Slide the tailwheel bracket over the rudder and rudder
post. Glue the bracket to the rudder only . Do not glue the
bracket to the rudder post.

Radio Setup

❏
1. Remove the stock servo arms from all three of the
servos, and temporarily connect the servos and ESC to your
receiver. Power up the system and center all three servos.
❏
2. Refer to the " Plastic Tree Parts" listing on page 5 and
select the correct offset double-sided servo arm for the
aileron servo you will be using. There are three arms to
choose from:
Servo Arm A Hitec HS-55, Hitec HS-50, Futaba 3108M
Servo Arm B Futaba S3103, Airtronics 94091
Servo Arm C JR 241
❏
3. Install two Z-bend clevises into the underside of the
offset double-sided servo arm.
13