Jog Mode; Build Sample - XYZ Printing da Vinci 1.0 Pro User Manual

da Vinci 1.0 Pro

JOG MODE

Manually adjust the movement of X/Y/Z Axis for printer maintenance.
How to move the extruder:
UTILITIES
Z OFFSET
JOG MODE
CALIBRATE
Select a target to move:
●
Select "X-AXIS" to move extruder rightwards and leftwards
●
Select "Y-AXIS" to move extruder forwards and backwards
●
Select "Z-AXIS" to move the print bed
Adjust the distance
2
● Use "UP" and "DOWN" buttons to select the moving distance. Then, select "-" based on the desired distance
and press the "TO THE LEFT" button or select "+" and press the "TO THE RIGHT" button to adjust the moving
distance.
●
Press the "TO THE LEFT" button: The extruder will be adjusted rightwards/backwards or closer to the print bed.
●
Press the "TO THERIGHT" button: The extruder will be adjusted leftwards/forwards or away from the print bed.
CALIBRATE
Use the function to adjust the print bed and make adjustment based on the reference value. The printing
quality will be affected by the levelness of the print bed. If you want to confirm the levelness of the print bed,
turn on the function to measure and check recommended adjustment.
UTILITIES
JOG MODE
CALIBRATE

BUILD SAMPLE

Refer to P.15 for CALIBRATE
BUILD SAMPLE
3 built-in samples are stored in the printer. You can learn to use the printer through building samples.
UTILITIES
CALIBRATE
BUILD SAMPLE
CHANGE NOZZLE
Stick the bed tape onto the print bed before printing
P 7
JOG MODE
X-AXIS
Y-AXIS
Z-AXIS
CALIBRATE
ARE YOU SURE?
NO
YES
X-AXIS [ OK ] >> EXIT
■
[ － ] [ 001mm ] [ ＋ ]
010mm
020mm
V.1.1