XYZ Printing da Vinci 1.0 Pro User Manual page 13

da Vinci 1.0 Pro
Functional operations and descriptions
Install and Load Filament
● Install Filament Cartridge from XYZprinting
◆ Remove the filament stopper and tape and
install the filament cartridge into the empty
slot.
◆ Insert filament into the guide hole until the printer
starts to load filament.
◆ Press the release arm to open the feeding path
while inserting the filament
Then, activate LOAD FILAMENT function
◆
on the printer
*Recommend using a clips and other tools to cut the tips of the filaments to generate a tapered tip of 45 degrees, and
to straighten the filaments to facilitate the filament loading process.
Activate LOAD FILAMENT function
on the control panel
● To use XYZprinting filament and apply the
recommended temperature settings,select "YES"
USE XYZPRINTING
CARTRIDGE NOW?
> YES
A. Wait for the extruder to heat up
As the temperature reaches op-
B.
erating setting the printer loads
automatically the filament, and
filament loading is completed
C.
Check if the filament flows out
from the nozzle. If the filament has
flowed out, please press "OK" to
complete the loading process
P 13
UTILITIES > CHANGE CART > LOAD FILAMENT
◆ Place and push to click the
cartridge locker
◆ Filament loading is completed
● Install Compatible filament
Hang the spool on the
filament spool holder
prepared by yourself
◆ Remove the cartridge from the
cartridge slot if any to use your own
filament
CHANGE CARTRIDGE
>LOAD FILAMENT
●
Select "NO" if filaments of other brands are used.
USE XYZPRINTING
CARTRIDGE NOW?
> NO
USER FILAMENT
APPLY SETTING
>NOZZLE: 210 ℃
※ To use pre-defined temperature settings:
Select "APPLY SETTING" directly to enter the
workflow shown on the left
※ To specify your own temperature settings:Select the
printer component using the new settings. To set
the heating temperature, please refer to instructions
provided for "Temperature Settings" function Select
"APPLY SETTING" to start applying your specified
temperature settings. The process on the left will start
and the printing component will start to heat up
Remarks: The temperature setting in this procedure is appli-
cable only to 3D Builder application software devel-
oped by Microsoft. For more information about 3D
Builder, please visit the Microsoft website
V.1.1