Activating The Database - IBM Netfinity 5100 8658 11Y Manual

where
v databasename is the name of the database
v d is the drive where the database is created
3. Press Enter.
4. Next, you must configure the tables for ODBC
database support. For information on configuring the
database for ODBC, refer to "ODBC database
configuration" on page 134. For information on creating
the tables, refer to "Creating the Netfinity Manager
tables" on page 135.
5. Finally, you must bind the database. For information on
binding the database, refer to "Activating the
database".
Installing the database on OS/2:
1. Insert the Netfinity Manager CD into the CD-ROM drive
(in this example, drive D; individual drive letters might
be different).
2. Start an OS/2 window or full-screen session.
3. Make the CD-ROM drive the active drive.
Type D: and then press Enter.
4. Type the following command at the OS/2 prompt:
NETFINDB CREATE /DBNAME=databasename /DRIVE=d
where databasename is the name of the database and
d is the drive where the database will be located.
Note: If any part of the database already exists, the
utility program will create only the portions of the
database that are missing.
5. Press Enter.

Activating the database

The following information describes how to connect, bind,
and grant privileges to the database.
1. Connecting to the Database
a. Start a DB2 command window.
b. Type the following command:
DB2 CONNECT TO databasename
where databasename is the name of the database
as specified in the database installation step.
c. Press Enter.
2. Bind the package and the database
To prepare SQL statements stored in the bind file and
store the package in the database, perform the
following steps from a system on which Netfinity
Netfinity Manager
127