switch back to the primary adapter when the
primary adapter comes back online. In this case,
issue the command:
LOAD d:\path\PCNTNW SCAN
where d and path are the drive and path where the
driver is located. This command causes the device
driver to locate the primary adapter and switch the
Ethernet traffic to it.
Ethernet port connector
The following table shows the pin-number assignments for
the RJ-45 connector. These assignments apply to both
10BASE-T and 100BASE-TX devices.
Table 18. Ethernet RJ-45 connector pin-number
assignments.
Pin
Signal
1
Transmit data+
2
Transmit data-
3
Receive data+
4
Not connected
Advanced System Management ports
Your server has three communication ports dedicated to
the Netfinity Advanced System Management Processor.
One port uses a standard D-shell serial-port connector,
connector C. The other two ports, which are used for the
RS-485 function, use a dual RJ-45 connector.
You can attach a dedicated modem to the D-shell
system-management connector on the rear of your server
to communicate with the integrated Netfinity Advanced
System Management Processor.
The RS-485 function uses the RJ-45 system-management
connectors. This function enables you to connect the
Advanced System Management Processors of several
rack-mounted servers so that they can communicate with
each other in half-duplex mode.
110
: Netfinity 5100 Type 8658 Models 11Y, 21Y, 31Y,
41Y, 51Y, 1RY, 2RY, 3RY, 4RY, 5RY
Pin
Signal
5
Not connected
6
Receive data -
7
Not connected
8
Not connected