Remove The Millivolt Board; Remove The Air Duct - kozy heat Jackson 911 Installation And Operation Manual

MILLIVOLT BOARD. Figures C-2 & C-3.
2.
A. Remove the burner cover by lifting the front of the
cover up, then carefully sliding the burner tube off
the orifice. Remove entire assembly from the fire-
box (Figure C-2).
B. Loosen & remove the (2) 1/4" nuts securing
the millivolt board and lift it up and off the
studs and remove from the fireplace.
IMPORTANT: BE CAREFUL NOT TO DAMAGE THE
GASKET UNDER THE BOARD.
NOTE: The millivolt board is secured with (2) nuts at
the factory. After the millivolt board is properly
installed it must be secured with 8 nuts (included).
The burner / cover assembly is then placed over
the millivolt board.
3. REMOVE THE AIR DUCT. Figure C-4.
A. Lift the air duct (manifold) up from the top of the firebox and set aside.
Figure C-2
Figure C-3
Figure C4
PAGE 9