Konica Minolta bizhub 20 Service Manual page 144

(11) General communications-related
Code 1
B0
B0
B0
BF
BF
BF
* Establishment of FAX communication:
FAX communication is established when the calling station receives a DIS
(reception capability) signal from the called station and the called station receives a
NSS or DCS (communications test) signal from the calling station.
(12) Transmission in V. 34 mode
Code 1
C0
C0
C0
C0
C0
C0
C0
C0
C0
C0
C0
Code 2
02 Unable to receive the next-page data.
Unable to receive polling even during turn-around
03
transmission due to call reservation.
04 PC interface error.
Communication canceled by pressing the Stop/Exit
01
button before establishment of FAX communication*.
Communication canceled by pressing the Stop/Exit
02
button after establishment of FAX communication*.
Transmission canceled due to a scanning error caused
03 by no document or document feed problem in ADF
scanning in real time transmission.
Code 2
01 No common modulation mode or failed to poll.
02 Unable to detect JM.
03 Unable to detect CM.
04 Unable to detect CJ.
10 Cannot finish V. 34 negotiation or training.
Modem error is detected during V. 34 negotiation or
11 training. (For modem error details, refer to the table
given on the next page.)
Modem error is detected during sending of commands.
20 (For modem error details, refer to the table given on the
next page.)
Modem error is detected during receiving of commands.
21 (For modem error details, refer to the table given on the
next page.)
22 Control channel connection time-out.
Modem error is detected during sending of video
30 signals. (For modem error details, refer to the table
given on the next page.)
Modem error is detected during receiving of video
31 signals. (For modem error details, refer to the table
given on the next page.)
3-69
Causes
Causes
Confidential