Table of Contents
Advertisement
Section 4 —Entrapment Protection Devices for Sliding Gates
Entrapment Protection Device
Attention
Gate edge
sensors
Warning signs must be
on both sides
2 ¼" safety mesh
prevents reach-
through: height not
less than 48 inches
Physical travel
stop, both ends
This schematic view is not meant to recommend a specific configuration. It is not meant to point out
the important elements of a proper automatic vehicular gate installation. The gate operator is only
one component in the total system. Always install a separate pedestrian gate.
Schematic for Sliding Gates
gap
Keep this
small as possible
Photo Eyes for
both directions
each side of gate
32
Guard posts
as
Gate edge sensor,
on leading edge
and trailing edge
Note: Wheels and covers are
not shown. However, all gate
wheels must be covered.
© 2012 Installation and Reference Manual D0125 Rev. H
Photo Eyes for
both directions
Physical travel
stop, both ends
Stop and reset
button
Access controls
at least six feet
away from gate
and operator
Audio alarm
Advertisement
Table of Contents
