Page 1
Release the strap from the adjuster, and remove the strap from the VELCRO pad. Note: VELCRO is a trademark of Velcro Industries B.V. Insert the strap through the PW50 and VELCRO pad. Make sure the D-ring and adjuster are oriented as shown at the top of the PW50. VELCRO pad...
Page 2
Place the strap on the VELCRO pad, and route the strap through the adjuster and D-ring as shown. VELCRO pad 4 Close the VELCRO pad over the strap. You are now ready to use the printer with the handstrap. (Optional) Install another handstrap on the other side of the PW50.