Setting Up Serial Communications - Intermec PW50 User Manual

Chapter 2 — Configuring the PW50

Setting Up Serial Communications

16
To set up Bluetooth communications with a scanner
1 Make sure that the PW50 is not connected to a serial cable.
2 Download and install EasySet on your host PC.
3 Create the following bar code labels using EasySet:
• Administrator reset factory defaults
• Bluetooth parameters - security - not active
• Bluetooth parameters - connect/disconnect - compose BT
address
• Bluetooth parameters - security - compose PIN:
4 Scan the bar code labels with the Bluetooth scanner.
Before you can establish a serial connection, you need to make sure
that the settings on the PC match the settings on the PW50.
Serial Port Default Settings on the PW50
Parameter Default Setting
Baud rate 115200
Data bits 8
Parity None
Stop bits 1
Flow control Hardware
PW50 Workboard Printer User's Guide