Using Extended Test Mode - Intermec PW50 User Manual

PW50 Workboard Printer User's Guide
3 Release the buttons. The following sequence of events occurs.
Test Mode Events
Event
1
The printer is performing a test feed (sensor
calibration), and media is continuously
feeding as a series of testprints is printed.
2
The indicator blinks once for each testprint
printed.
3
The printer entered Dump mode. While
the printer is in Dump mode, it scans the
communication ports. Any characters
received on the communication ports are
printed.
4
Press Feed to exit Dump mode. When you
exit Dump mode, the printer returns to
Ready mode.

Using Extended Test Mode

Use Extended Test mode to run additional diagnostic tests, including
printing specific testprints, entering Dump mode, and resetting to
factory defaults.
To enter Extended Test mode
1 Make sure that the printer is loaded with media.
2 Press the media cover release button to open the media cover.
3 Press the Standby button to turn the printer off.
4 Press and hold the Standby and Feed buttons until the PW50
beeps.
5 Close the media cover. You are now in Extended Test mode.
6 Press the Standby button to cycle through the Extended Test
mode options.
Chapter 2 — Configuring the PW50
Indicator
Status LED is steady red
Intermec Ready-to-Work™
indicator blinks
Intermec Ready-to-Work
indicator is on and status
LED is steady red
21