Carrier 59SP5A Installation, Start-Up, Operating And Service And Maintenance Instructions page 27
100 series
Hide thumbs
Also See for 59SP5A:
- Product data (15 pages) ,
- Installation, start-up, operating and service and maintenance instructions (78 pages) ,
- Product data (17 pages)
Advertisement
COMBUSTION
- AIR PIPE
(SEEVENTING SECTION) \\
\
\
A 12-IN.
(305 mm) MIN HORIZONTAL
PIPE
SECTION
IS RECOMMENDED
WITH A
5 TO 8 FT / 1.5 TO 2.4 M) VENT
_VENT
30 IN. (762 mm)
ii
MANUAL
S
SHUTOFF
GAS VALVE
TRAP
COIL
CONDENSATE--
TRAP
ROLLOUT PROTECTION
REQUIRED
Install 12"x 22"(305
x 559 mm) sheet
metal in front of burner
compartment
NOTE:
FURNACE
SHOWN
AS DIRECT
VENT
APPLICATION.
REFER
TO THE
VENTING
SECTION
FOR ALLOWABLE
VENT
CONFIGURATIONS
Fig. 27 - Working
Platform
for Attic Installation
Al1154
COMBUSTION-AIR
PIPE
(SEE VENTING SECTION)
--_
....
VENT
ROD
,/
NOTE: EXTEND
IRON OUT FOR
COIL
o%o%,o2 /
LOCATORS
HEX NUT
& WASHER (4)
REQD. PER ROD
NOTES: 1. A 1 In. (25mm) clearance minimum between
top of furnace and combustible material
2. The entire length of furnace must be
supported when furnace is used in horizontal
position to ensure proper drainage.
3. Furnace shown is a direct vent application,
Refer to the Venting section for allowable vent
configurations,
Fig. 28 - Suspended
Furnace
Installation
Al1155
27
Advertisement
