Carrier 59SP5A Installation, Start-Up, Operating And Service And Maintenance Instructions page 17

If alternate vent position
is required, loosen clamp
on vent elbow inlet.
Remove trap from collector
box.
Remove relief tube from
relief port on condensate
trap.
Remove front pressure
switch tube and discard.
(_) emove relief tube
from port on collector
box.
(1 AND 2 STAGE UNITS)
Remove middle and right
plug from collector box.
ii
Unconverted Factory Trap Configuration
As Viewed in the Horizontal Left Orientation
(_ otate elbow to
desired position
and torque clamp
on inlet 15 lb.-in.
Install plug in open
ports on collector box.
Connect relief tube to port
on collector box.
(_ Slide relief tube in stand-offs to adjust
length.
Connect tube from Loose
Parts bag to port on front
pressure switch.
(_ ttach condensate trap with screw to
collector box.
(_ Align trap over middle and right-hand port on
collector box.
(1 AND 2 STAGE UNITS)
Route pressure switch tube
underneath relief tube and
connect to port on
collector box.
Connect relief tube to relief
port on condensate trap.
Horizontal Left Trap Configuration
Fig. ll - Horizontal Left Configuration
Al1282
17