Pattern Edit Menu; Track Enable/Mute Buttons; Name Pattern; Pattern Length - E-Mu MP-7 command station Owner's Manual

Pattern Edit
Menu
Track Enable/Mute
Buttons

Name Pattern

Pattern Length

72 E-MU Systems
The Pattern Edit menu contains housekeeping, pattern editing filters and
other tools.
The Pattern Edit button is DISABLED unless you are in Pattern Mode!
IMPORTANT: In Pattern Edit mode, Track Enable/Mute buttons are used
to select which tracks will be affected by the editing operation.
Any enabled tracks will be edited and any disabled tracks will be unaffected
by the editing operation—Quantize, Thin Events, Erase Events, Velocity
Scale/Shift, Extend or Transpose.
Patterns can be named with up to 16 characters. Position the cursor under
the character location and use the data entry control to change the
character.
PATTERN NAME
1
006 Metallic 6
Patterns can be anywhere from one to thirty two measures in length. A
pattern loops when it reaches the end whether in record or playback
modes.
A pattern's length can also be changed at any time, before or after
recording. If you increase the length of a pattern after recording, it will play
silently for the extra time unless new data is recorded there. If you shorten
a pattern's length after recording, it will play up to it's new length then
loop. Changing the length of a pattern does not change any data until you
save it. If you save a shortened pattern, the unplayed data will be erased.
To Set the Pattern Length from the Pattern Edit menu
Select Pattern Edit mode from Pattern mode.
1.
Locate the Pattern Length screen using the data entry control.
2.
PATTERN LENGTH
Length: 32 bars
Move the cursor to the lower line of the display using either cursor key,
3.
then set the length of the pattern using the data entry control.
Sequencer

Pattern Edit Menu