Table of Contents
Advertisement
O O O O
The Event Source
parameter (page 111) controls
how pattern settings are used in
Song mode.
_ _ _ _
Too much controller
information can clog the
sequencer causing sluggish
performance and sloppy timing.
Use the "Thin Events" function
(page 81) to reduce the amount
of controller data in the pattern.
Saving Patterns
When you save a pattern (page 285), the following settings are also saved
(as set at the moment you saved). These setting are restored just before
pattern playback.
• Tempo & Meter
• Master FX setup (See page 152)
• Track to MIDI Channel mapping (See page 94)
• Track Mutes .....................................................
• Bank/Program changes ...................................
• Initial Volume & Pan settings.........................
• Mix Output setup (See page 150) .....................
• Arp Status (off, on, preset, master) ....................
To Record Realtime Controller Data
You can mix and embellish your patterns by recording continuous
controllers along with note data.
Start by recording and saving a pattern.
1.
Recording Quick Edits
The Quick Edit knobs are only active on the Basic Channel (the channel
currently displayed in the Preset View screen).
Select Quick Edit mode by pressing the Controller Function Select
2.
button.
Select the channel with the preset you wish to Quick Edit.
3.
Practice your knob movements before recording by Playing the
4.
pattern and twisting the knobs.
When you're ready to record, press Record while the sequencer is
5.
playing (to punch-in), then perform the knob movements.
Record Multitrack Volume and Pan Information
You can record Volume and Pan information for all 16 channels simulta-
neously by using Volume Knob mode. You'll be recording multichannel
volume or pan data onto a track. The default channel assignment will
rechannelize this data to a single channel. You must change this.
Select a track for the Realtime Controller data.
6.
Press the Pattern Edit button and scroll to the "Channel Assign" page.
7.
Set the track to MultiA. Now the track will record multichannel data.
8.
Press the Pattern Edit button to exit the menu.
9.
Automating the Volume of each Channel
Select Volume knob mode by repeatedly pressing the Controller
10.
Function Select button (page 37).
Select Mix View mode if you wish to view the volume settings.
11.
Sequencer
Pattern Mode
These parameters
are stored for each
track used in the
pattern.
MP-7 Owners Manual 61
Advertisement
Table of Contents
