E-Mu MP-7 command station Owner's Manual page 139

   
XMix Quick Reference
1. Hold Tap and hit Play.
2. Select the Source Pattern.
3. Select the Dest. Track.
4. Select the Source Track.
• Press Play to Exit XMix.
Select the Source Pattern using the data entry control. (This is the
3.
pattern you want to copy tracks from.)
Press Enter to lock in your Source Pattern selection. The display
4.
changes to:
XMIX Select Dest Track
DestPat: 022
The track enable LEDs will be lit on tracks which have recorded data.
5.
Muted tracks will be flashing. Select the track you want to replace by
pressing its track button. The display changes to:
XMIX Select Source Track
DestPat: 022
The track enable LEDs will be flashing on any tracks with recorded data.
6.
Select the new track you want by pressing its track button. The old
track in the destination pattern will instantly be replaced with the new
track from the source pattern.
To Change the Mute Settings while in XMix mode:
The Track Enable/Mute LED is normally off while in XMix mode. Press
7.
the Track Enable/Mute button (lighting the LED) to switch the
buttons back into mute select mode. Press the button again to go back
into XMix track select mode.
To Replace Another Track
Notice that the display is back to the one shown in step four. To replace
8.
another track, simply select the next one you want replaced. Then
select the source track and it's done!
To Select Another Source Pattern
Turn the data entry control to select another source pattern. The
9.
display changes to read Select Source Pattern. Select a new source
pattern, then press Enter to lock it in.
Select the Destination Track, then the Source Track. Done.
10.
To Exit XMix Mode:
Press the Play button.
11.
To Save the New Pattern
• The Save/Copy LED is flashing. Press the Save/Copy button to jump to
the Save Pattern screen.
0
SrcPat: 025
0
SrcPat: 025
MP-7 Owners Manual 127
Sequencer
Live Performance Features
0
0