E-Mu MP-7 command station Owner's Manual page 42

   
If you want to record the
Trigger Buttons on a single MIDI
channel, set the track Channel
Assignment to the same channel
as the trigger buttons.
30 E-MU Systems
To Record the Trigger Buttons
You can record the note trigger buttons into the sequencer in order to
automate your multi-arpeggiator performance. These instructions also
apply to recording trigger buttons without the arpeggiators.
Set up the multichannel arpeggiators as described on page 28.
1.
Press the Pattern Edit button and scroll to the Channel Assign screen
2.
shown below.
Set the channel setting to MultiA and Dest: internal, as shown in the
3.
screen below. (The trigger buttons are set to play on multiple MIDI channels.
if this track were not set to Multi, all channels would be rechannelized to the
selected channel and the triggers would play back incorrectly.)
T
01 CHANNEL ASSIGN
Channel: MultiA
Make sure that the Trigger Buttons destinations are set to "seq" as
4.
shown below. (This sends the trigger keys to the sequencer input.)
T1 TRIGGERS C3
Latch:on Ch: 01A
Save the Multisetup.
5.
Start with a new blank pattern and set the pattern length. Choose 20
6.
bars or so to start.
Restore the Multisetup. (Just to make sure everything is set up correctly.)
7.
Press Record, then Play. Start recording the trigger buttons.
8.
Instant Gratification
Multi-Channel Arpeggiator
Dest: int
Vel: 127
seq
Set to
seq