Duplicate Flash - E-Mu MP-7 command station Owner's Manual

Duplicate Flash

_ _ _ _
If there are no Flash
SIMMs in the unit, or if the
SIMMs are in the wrong slots,
an error message will be
displayed.
294 E-MU Systems
This utility allows you to duplicate Flash SIMMs using MP-7. Both Sound
and Preset data is copied when a Flash SIMM is duplicated. A factory sound
SIMM cannot be copied using this utility.
WARNING: dangerous voltages are exposed inside MP-7! Make sure
power is completely disconnected from MP-7 before removing the top
panel. Replace the top panel before restoring power to the unit.
The two sound SIMM sockets in MP-7 are marked 0 and 1. These are located
behind the controller knobs on the circuit board. The Flash SIMM you want
to copy MUST be placed into SIMM Socket 0. The destination Flash SIMM
must be placed in SIMM socket 1.
DUPLICATE SLOT 0 FLASH
Start
Make sure the two Flash SIMM are located in the required MP-7 SIMM
1.
sockets.
Press the Save/Copy menu button.
2.
Rotate the data entry control to select the "Duplicate Flash SIMM"
3.
screen shown above.
Move the cursor to the bottom line and press Enter. The following
4.
screen appears and the Enter LED will be flashing.
Press ENTER to overwrite
the Flash SIMM in Slot 1
Press Enter again to confirm or any other button to abort. The
5.
following screen appears and the SIMM is copied.
DUPLICATING SLOT 0 -> SLOT 1
(Takes about 5 minutes)
When MP-7 has finished duplicating the SIMM, turn power off, remove
6.
the copied SIMM, then reboot. That's it!
Save/Copy Menu
Duplicate Flash