Pitney Bowes FastPac DI900 Operator's Manual page 12

DI900/DI950/DI950e Operator Guide Addendum
Creating a Job
that Uses the
Universal Feeder
(continued)
12
5. The Create - Select Next Item screen displays. Select the appropriate
option.
NOTE: These instructions apply to items being fed by the Universal Feeder.
Menu Options Associated Options/Actions
Reply Card a.
Reply Envelope
Pre-Folded Insert
Small Booklet
Slip
Generic Insert
Large Booklet
b.
Stiff Media
Refer to the Insert Options section in this document for specific
information about each of the related menu options.
Sheet a.
b.
c.
d.
If this is a scanning job, follow the steps in this section.
Otherwise, go to step b.
The Scan Type screen displays. Select "External Scan
Definition".
NOTE: The External Scan Definition option is only available
if the Universal Feeder is present on the system. If the job
requires a Universal Feeder, External Scan Definition is the
only available option.
Select the appropriate options for the insert. Press "Accept"
when done.
Select the "Custom Feeder" option. The Sheet - Personalized
Create screen appears. Select the appropriate personalization
option. The Create - Verify Sheet screen appears.
If this is a scanning job, follow the steps below. Otherwise, go
to step c.
• The Scan Type screen displays. Select "External Scan
Definition".
NOTE: The External Scan Definition option is only
available if the Custom Feeder is present on the system.
If the job requires a Custom Feeder, External Scan
Definition is the only available option.
• The Scan Configuration screen displays. Select the
appropriate Scan Configuration.
• The Content in Line with Marks screen displays. If there is
content in line with the scan marks, select "Yes". If there is
no content in line with the scan marks, select "No".
• If you selected "Yes", the Mark Locations Settings screen
appears. Follow the steps below to enter the various
mark-related measurements:
- Select an option, then use the UP/DOWN arrow keys
to enter the appropriate measurement (in millimeters).
- Press "Accept" when done entering the
measurement.
- Once all measurements have been entered, select
"Accept".
Select the appropriate Sheet options for the job. Press
"Accept" when done.
NOTE: If this is a scan job, set the Select Feed setting.
Refer to the Sheet Options table in this document for more
information about each of the related menu options.
Select the appropriate Fold options for the sheet. Press
"Accept" when done.
Refer to the Fold Options table in this document for specific
information about each of the related menu items.
SV62081 Rev. A