Advertisement
Lower Oven Self-Cleanincj Cycle
SELF=CLEAN CYCLE
The SELF CLEAN pad controls the Self-Cleaning
feature.
When used with a Delay Start pad, a delayed
Self-Cleaning
cycle may also be programmed.
The Self clean feature
allows for any Self-Cleaning
cycle time from 2 (2:00) to 4
hours (4:00).
You may also choose the clean time in 1 minute
increments (for example
2 hours and 50 minutes) by pressing
the corresponding
number keypads.
If you are planning
to use the oven directly
after a self-clean
cycle remember
to allow time for the oven to cool down and
the oven door to unlock.
This normally
takes about one hour.
So a 3 hour self-clean
cycle will actually
take about 4 hours
to complete.
*It is recommend
to use a 2 hour self-clean
cycle for llghf soils,
a 3 hour cycle for average
soils, and a 4 hour cycle for heavy
soils (to assure satisfactory
results).
NOTE: The kitchen
area should be well ventilated
using an
open window,
ventilation
fan or exhaust hood during the
Self-Clean
cycle. This will help eliminate
the normal
odors
associated
with the Self-Clean
cycle.
See example
below to start an immediate
Self-Cleaning
cycle or to set a Delay Start time of 9:00 o'clock
and shut-
off automatically
(example
provided
is a default
3 hour
Self-Clean
cycle)
.
2.
.
Be sure the clock
is set with
the correct
time
of day,
the
oven
is EMPTY
and
the oven
door
is closed.
Press SELFCLEAN.
The control
wiii automatically
clean for a 3 hour period
(default
self-cleaning
cycle time). Note: If a 2 or 4 hour
clean
time is desired,
press 2 0 0 for 2 hour or press 4 0
0 for a 4 hour clean time. Set the cleaning
time based
on the amount of soih lighh medium
or heavy (_See
above).
Press START.
As soon
as the
control
is set,
the
motor
driven oven door
loci< will begin to close automatically.
Once the door
has been locked the "DOOR
LOCKED"
indicator light
will stop flashing
and remain on.
Note: Allow about 15 seconds for the oven door loci< to close.
Nofe:
If the optional
delay Self=Clean feafure
is needed,
finish steps 4-6.
4.
Press DELAY START.
5.
Enter
the desired
Self-Clean
starting
time
using
the
number
pads
9 00.
6.
Press START.
The control
wiii calculate
forward
from
the set start
time
to determine
when
the Self-Cleaning
cycle
should
end.
The Self-Cleaning
cycle
will turn
on automatically
at the
set time.
° To avoid possible
burns use care when opening
the oven
door after the Self-Cleaning
cycle. Stand to the side of
the oven when opening
the door to allow
hot air or steam
to escape.
DO NOT force the oven door open. This can damage
the automatic
door locking system. Use caution
and
avoid
possible burns when opening
the door after the
Self-Cleaning
cycle has completed.
The oven may still be
VERY HOT.
When fhe Self=Clean
Cycle is Complefed
Once the oven has cooled
down for approximately
1 HOUR,
and the "DOOR
LOCKED"
icon is no longer displayed,
the
oven door can then be opened.
Stopping or Inferrupfing
a Self=Cleanlng
Cycle
If it becomes
necessary
to stop or interrupt a self-cleaning
cycle due to excessive smoke or fire in the oven:
1.
Press STOP.
2.
Once the oven has cooled
down for approximately
1
HOUR, and the "DOOR
LOCKED"
icon is no longer
displayed,
the oven door can then be opened.
If a self-clean
cycle was started
but did not finish due to a
power failure, your oven may not be completely
cleaned.
After power has been restored
and the oven door has
unlocked,
set for another
self-clean
if needed.
38
Advertisement
