Download Print this page

Kenmore 790.4911 Series Use & Care Manual page 15

Microwave/wall oven combination

Advertisement

Microwave
Manual Operation
TIME COOKING
Your Microwave
Oven can be programmed
up to 99
minutes 59 seconds (99.59).
Always
enter the seconds after
the minutes, even if they are both zeros.
°
Suppose you want to cool< for 5 minutes at 100%.
1. Press TUME COOK
2. Enter cooking
time by pressing 5 0 0 on the numeric
pads.
3. Press START
TO SET POWER LEVEL
Using lower power levels increases the cooking time which is
recommended
for foods such as cheese, mill< and long slow
cooking
of meats. Consult cookbook
or recipes for specific
recommendations.
e
].
Suppose you want to cool< for 5 minutes at 70%.
Enter cooking
time by pressing 5 0 0 on the numeric
pads.
2. Press POWER LEVEL
3. Enter power level by pressing 7 on the numeric
pads.
4. Press START
Power level
Common words for power levels
100
High
9O
8O
70
Medium High
6O
50
Medium
40
30
Med Low/Defrost
2O
10
Low
MANUAL
DEFROST
If the food that you wish to defrost
is not listed on the
Defrost chart or is above or below the limits in the "Amount"
column on the Defrost chart, you need to defrost
manually.
You can defrost
any frozen
food, either raw or previously
cooked,
by using Power level 30. Follow the exact
procedure
found under Time cooking.
Estimate defrosting
time and
lower your power level to 30%.
For either raw or previously
cooked frozen food the rule of
thumb is approximately
5 minutes per pound.
For example,
defrost
5 minutes for 1 pound of frozen
spaghetti
sauce.
Always
stop the oven periodically
to remove or separate
the
portions
that are defrosted.
If food is not defrosted
at the
end of the estimated
defrosting
time, program
the oven in 1
minute increments
on power level 30 until totally
defrosted.
When using plastic containers
from the freezer,
defrost
only
long enough to remove from the plastic in order to place in
a microwave-safe
dish.
*
Suppose you want to defrost
for 5 minutes.
1. Enter cooking
time by pressing 5 0 0 on the numeric
pads.
2. Press POWER LEVEL
3. Enter power level by pressing 3 on the numeric
pads.
4. Press START
15

Advertisement

loading