Aastra DT4X3 User Guid page 46

User Manual
Cordless Phones for MX-ONE™
No-movement alarm: If no movement is detected during a preset time (default 30 seconds), the
No-movement alarm will be triggered.
When an alarm is triggered, the following occurs;
• A Man-down warning. Cancel? or No- movement warning. Cancel? dialog window is
shown in the display, and a warning tone is also signaling during a period (default 7 seconds)
before the alarm is sent.
• To prevent the alarm from being sent and silencing the warning tone, do one of the
following:
- Press any key/button. The alarm will be reset.
- Put the handset in a charger. The alarm will be temporarily disabled indicated by that the
corresponding alarm icon is hidden. The alarm will be enabled when removing it from the
charger.
• If no key/button is pressed during the warning tone, the alarm is sent. Depending on set
parameters, a beep/vibrator/LED signal confirms that the alarm has been sent.
• An acoustic location signal (ALS) may be activated after the alarm has been sent, or a call
may be established to a predefined number. See 12.4 Acoustic Location signal and 12.6
Automatic Call after Alarm.
• Information about the handset's location may be sent along with the alarm, see
with Location Information
See also 13.8.10 Alarm Settings
12.3 Alarm with Location Information
Information about the handset's location can be sent along with an alarm. The location can be
added as follows;
• An approximately location given by the closest Base Station (see the handset's
Configuration Manual) or,
Note: This function requires CPDM3
12.3.1 Alarm with Data
The data must manually be defined and stored by the user, see
recommended to add a shortcut for quick access to the "Edit alarm data" menu, see
Shortcuts on page 55.
12.4 Acoustic Location Signal
Depending on set parameters, the ramped up ALS is played after an alarm. The signal is always
ramped from the lowest volume to the highest. Press
Depending on the PDM settings, it is possible to make the user enter a password when turning
the ALS off. The password is the same as the phone lock password.
ALS is configurable for Man-down & No-movement alarm, and Push-button alarm. See the
handset's Configuration Manual for more information.
12.5 Automatic Call after Alarm
A handset can be setup to call a pre-defined number after an alarm has been sent. It is also
possible to dial the number without sending an alarm by pressing a push-button that is not
1424-EN/LZT 103 089 B 2014-04-13
on page 40.
on page 63.
12.3 Alarm
Edit Alarm Data on page 62. It is
13.7
to turn the ALS off.
40