Aastra DT4X3 User Guid page 32

User Manual
Cordless Phones for MX-ONE™
7.3 Outgoing Call
7.3.1 Pre-Dial
Enter the number and press
dialling. If needed, press "Clear" to erase the number. By using the navigation key it is possible
to step and add/delete a digit in a number.
The tone sender in a pre-dialed number can be turned on by long pressing
An international number can be dialled from the handset by entering a + character followed by
the country code and local number. To enter the + character, long press the 0 key until the
character is shown in the display.
Note the + character cannot be entered and international numbers cannot be dialled in the
following circumstances:
• if the 0 key has been configured as a hot key.
• if the handset has been set up to perform advanced functions normally used by a system
administrator, as described in the Admin Menu.
7.3.2 Post-Dial with Headset Button
If a headset is used, it is possible to press its button
to be dialled.
7.3.3 Dial Using a Pre-programmed Navigation Key, Hot Key, Soft key, or Headset Button
A Navigation key, Hot key, Soft key, or a headset button
Press the pre-programmed key/button to dial the number. The call will automatically be
connected.
7.3.4 Dial a Number from the Call list
Tip: It is also possible to dial a number from the Call list by pressing
the list, and then press "Call" or
1 Open the menu by pressing the "Menu" soft key.
2 Select
3 Select "Call list".
4 Select a number.
5 Press
dialled. Press "More" and select "Edit number". The 25 last received, dialled or missed
calls are stored in a call list. See
7.3.5 Dial Last Called Number with Headset Button
If a headset is used, the headset button can be pressed to dial the last called number. This
requires that the headset button is configured via the PDM/Device Manager.
7.3.6 Dial the Sender of a Message
It is possible to call the sender of a message stored in the message list.
1 Open the menu by pressing the "Menu" soft key.
2.The headset button must be configured in the WinPDM.
1424-EN/LZT 103 089 B 2014-04-13
to get the line. The number is shown on the display while
.
.
or the soft key "Call" to dial. The number can be edited before the call is
5.1 Calls
2
to get a ring tone and then enter the number
2
can be programmed with a number.
, selecting a number in
on page 18.
.
26