Table of Contents
Advertisement
Chapter 6. Introduction to Tasks and Service Aids
Beginning with version 4.2 there are two top level menus seen by the user – Tasks and
Resources. Once a Task has been selected, then a list of resources is displayed for
selection to run the Task on. Or after selecting a Resource, a set of Tasks is displayed for
selection.
Tasks
Service Aids are invoked via a task selection from the following list:
Note: Refer to page 6-3 for a listing of service aids.
Add Resource to Resource List
AIX Shell Prompt
Backup and Restore Media
Bit Error Rate Service Aid
Certify Media
Change Hardware Vital Product Data
Configure Dials and LPFKs
Create Customized Diagnostic Configuration Diskette
Delete Resource from Resource List
Disk Maintenance
Display Configuration and Resource List
Display Hardware Error Report
Display Hardware Vital Product Data
Display or Change Bootlist
Display or Change BUMP Configuration
Display or Change Diagnostic Run Time Options
Display or Change Electronic Mode Switch
Display or Change Multi–processor Configuration
Display Previous Diagnostic Results
Display Service Hints
Display Software Product Data
Display Test Patterns
Download Microcode
Format Media
Generic Download Microcode
Periodic Diagnostics
Process Supplemental Media
Product Topology
Run Diagnostics
Run Error Log Analysis
SCSI Bus Analyzer
SSA Service Aids
Update Disk Based Diagnostics
7318 Serial Communications Network Server
6-1
Using the Service Aids
Advertisement
Table of Contents
