IBM 7013 J Series Operator's Manual page 133

5. The SELECT BOOT (STARTUP) DEVICE menu appears, which is similar to the
following:
SELECT BOOT (STARTUP) DEVICE
Select the device to BOOT (Startup) this machine.
WARNING: If you are using Token–Ring, selection of an
incorrect data rate can result in total disruption of the
Token–Ring network.
"==>" Shows the selected BOOT (startup) device
==> 1. Use Default Boot (Startup) Device
2. Token–Ring:
3. Token–Ring:
4. Ethernet:
Page 1 of 2
88. Next Page of Select BOOT (Startup) Device Menu
99. Return to Main Menu
Type the number for your selection, then press "ENTER"
(Use the "Backspace" key to correct errors)
6. Select the device to boot from. For example, choose 3 to boot from Token-Ring: slot 3,
16 Mb data rate. A screen similar to the following will appear:
SET OR CHANGE NETWORK ADDRESSES
Select an address to change
Currently selected BOOT (startup) device is:
Token–Ring: Slot 2, 16 Mb data rate
Hardware address ................................ 10005AC97CF1
1. Client address
(address of this machine)
2. BOOTP server address
(address of the remote machine you boot from)
3. Gateway address
(Optional, required if gateway used)
97. Return to Select BOOT (Startup) Device Menu (SAVES addresses)
99. Return to Main Menu (SAVES addresses)
Type the number for your selection, then press "ENTER"
(Use the "Backspace" key to correct errors)
Slot 3, 4 Mb data rate
Slot 3, 16 Mb data rate
Slot 4, 15–pin connector
009.003.001.027
009.003.001.008
000.000.000.000
3-53
Using SystemGuard