Programming Access Codes And Cards - jablotron JA-82K OASiS Installation Manual

13

Programming access codes and cards

Code name Amount
Service 1
Master 1
User 50
JA-82K control panel installation manual
Sequence
•
5 NC NC
Only programmable in Service Mode.
•
NC = new code (must be entered twice) – a card cannot be used.
•
Factory-default service code: 8080
•
This code can be changed but not erased.
•
Example: 5 4567 4567
•
∗5 MC NC
Only programmable if the system is totally unset (disarmed)
NC •
MC = master code or card (factory default 1234)
•
NC = new code or card entry – a numerical code has to be entered twice, but a card only
presented once
•
Either a code or a card can be programmed as a master code (to have both is
impossible).
•
The Master Code can be changed but not erased.
•
The Master Code's reaction is set/unset and it is assigned to all sections.
•
To reset the Master Code to the factory default 1234, enter 291 in Service Mode (this will
only affect the Master Code).
•
To make handing over the system to the end user easier, we recommend programming the
system card (provided with the control panel) to the master code.
•
Example:
•
∗6 MC nn NC
Only programmable if the system is totally unset
•
MC = Master Code or card.
•
nn = user code or card position from 01 to 50.
•
NC = new code or card entry.
•
Factory default: all user codes and cards are erased.
•
Each user position can have both a card and a code programmed to it (by using the
sequence ∗6 MC nn NC twice)
•
Each user code can have its own reaction programmed by an installer in Service Mode, and
with a split system, codes can be assigned to different sections.
•
Example:
To erase codes/cards enter:
∗6 MC nn 0000 erases the code and the card in user position nn.
∗6 MC 00 UC erases the code UC (or card UC) if programmed to any user position.
∗6 MC 00 0000 erases all user codes and cards in user positions 01 to 50.
fig. 19 Programming access codes and cards (only in the disarmed state)
∗
5 1234 and then presenting the card to the keypad's RFID reader
∗
6 1234 12 4345 (code 4345 will be programmed to user position 12)
- 20 -
Notes
MKH51102