Table of Contents
Advertisement
1 1
Machine safety regulations
Safety instructions on this manual are defined as Danger, Warning and Caution.
If you do not follow the instructoins, physical injuries and machine damages might be occurred.
Danger
: This indication should be observed definitely. If not, there will be a danger during the installation, conveyance and
maintenance of the machine.
Warning
: When you follow this indication, injuries from the machine can be prevented.
Caution
: When you follow this indication, error on the machine can be prevented.
1.1) Transporting
machine
Danger
1.2) Installing
machine
Warning
1.3) Repairing
machine
Caution
6
Those in charge of transporting the machine should have a full understanding of the machine.
The following indications should be followed when the machine is being transported.
ⓐ More than 2 people must transport the machine.
ⓑ To prevent accidents from occurring during transportation, wipe off the oil on the
machine compeletely.
The machine may not work properly or breakdown, if installed in certain places, Install the
machine where the following qualifications agree.
ⓐ Remove the package and wrappings from the top. Take special notice on the nails on the
wooden boxes.
ⓑ Dust and moisture stains and rusts the machine. Install an airconditioner and clean the
machine regularly.
ⓒ Keep the machine out of the sun.
ⓓ Leave sufficient space of more than 50cm behind, and on the right and left side of the
machine for repairing.
ⓔ EXPLOSION HAZARDS
Do not operate in explosive atmospheres. To avoid explosion, do not operate this machine
in an explosive atomsphere including a place where large quantities of aerosol spray
product are being used or where oxygen is being administered unless it has been
specifically certified for such operation.
ⓕ The machine is not provided with a local lighting due to the feature of machine.
Therefore the illumination of the working area must be fulfilled by end user.
[Refer] Details for machine installation are described in 4. Machine Installation.
When the machine needs to be repaired, only the assigned troubleshooting engineer educated
at the company should take charge.
ⓐ Before cleaning or repairing the machine, turn off the main power and wait 4 minutes till
the machine is completely out of power.
ⓑ Not any of the machine specifications or parts should be changed without consulting the
company. Such changes may make the operation dangerous.
ⓒ Spare parts produced by the company should only be used for replacements.
ⓓ Put all the safety covers back on the machine after the machine has been repaired.
Advertisement
Table of Contents
