Table of Contents
Advertisement
Finish the installation by completely tightening the screws in the same sequence.
c.
Install the air baffle.
4.
Install the access panel.
5.
Do one of the following:
6.
Slide the server into the rack.
o
Install the server into the rack.
o
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.
Press the Power On/Standby button.
9.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
Processor
The server supports single-processor and dual-processor operations.
WARNING:
internal system components to cool before touching them.
CAUTION:
should attempt to replace or install the processor in this server.
CAUTION:
configurations must contain processors with the same part number.
CAUTION:
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT:
installing the processor.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To avoid damage to the processor and system board, only authorized personnel
To prevent possible server malfunction and damage to the equipment, multiprocessor
To prevent possible server overheating, always populate processor socket 2 with a
If installing a processor with a faster speed, update the system ROM before
Removal and replacement procedures 53
Advertisement
Table of Contents
