Table of Contents
Advertisement
CAUTION:
module is fully inserted before pressing down.
Capacitor pack
CAUTION:
powered down and the last to be powered back up. Taking this precaution ensures that the system
does not erroneously mark the drives as failed when the server is powered up.
To remove the component:
Power down the server (on page 31).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 32).
o
Remove the server from the rack (on page 34).
o
Remove the access panel
4.
If the cache module is installed in the system board, remove the primary PCI riser cage
5.
on page 57).
If the existing cache module is connected to a capacitor pack, observe the FBWC module LEDs:
6.
If a backup is in progress, wait for the backup to complete.
o
If the backup is complete, or if the cache has failed, remove the controller from the server, and then
o
continue with the next step.
Disconnect the capacitor pack cable from the cache module.
7.
To prevent damage to the cache module during installation, be sure the cache
In systems that use external data storage, be sure that the server is the first unit to be
("Access
panel" on page 37).
("PCI riser
Removal and replacement procedures 67
cage"
Advertisement
Table of Contents
