Hot-plug drive blanks
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
If installed, remove the security bezel
1.
Remove the drive blank:
2.
Hot-plug LFF drive blank
o
To replace the LFF drive blank, slide the component into the bay until it clicks.
Hot-plug SFF drive blank
o
To replace the SFF drive blank, while pressing the release latch, slide the component into the bay
until it is fully seated.
Hot-plug drive
CAUTION:
all bays are populated with either a component or a blank.
To remove the component:
Back up all server data on the drive.
1.
If removing a drive from the rear drive cage, access the rear panel of the server
2.
rear
panel" on page 33).
Determine the status of the drive from the drive LED definitions.
3.
To prevent improper cooling and thermal damage, do not operate the server unless
("Remove the security bezel
To prevent improper cooling and thermal damage, do not operate the server unless
(optional)" on page 31).
("Access the product
Removal and replacement procedures 35