Kubota BX1860 Workshop Manual page 234

BX1860, BX2360, BX2660, RCK48(P)-18BX, RCK54(P)-23BX, RCK60B-23BX, LA203, LA243, WSM
Power Steering Cylinder
1. Remove the cotter pin and remove the slotted nut for tie-rod (1).
2. Remove the power steering cylinder mounting screws and
remove the power steering cylinder (2) with tie-rod.
(When reassembling)
NOTE
• Tighten the slotted nut to 18 N·m (1.8 kgf·m, 13 lbf·ft). If the
slot and pin hole do not meet, tighten the nut until they do
meet, and install the cotter pin.
• Be sure to split the cotter pin like an anchor.
Tie-rod slotted nut
Tightening torque
Power steering cylinder
mounting screw
(1) Tie-rod
4-S7
STEERING
18 to 34 N·m
1.8 to 3.5 kgf·m
13 to 25 lbf·ft
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
(2) Power Steering Cylinder
W1016645
KiSC issued 06, 2009 A