Kubota BX1860 Workshop Manual page 179

BX1860, BX2360, BX2660, RCK48(P)-18BX, RCK54(P)-23BX, RCK60B-23BX, LA203, LA243, WSM
Oil Cooler Cover
1. Remove the HST front cover.
2. Remove the HST front cover (1) not to damage the oil seal (5).
3. Remove the center section (6).
(When reassembling)
1. Do not damage the oil seal (5).
2. Tighten the HST mounting bolts and the nut to the factory
specifications.
Oil cooler cover mounting
bolt (M8)
Tightening torque
Oil cooler cover mounting
nut (M8)
(1) HST Front Cover
(2) Transaxle Assembly
(3) Bolt
Center Section and Valve Plates
1. Remove the valve plates (2).
(When reassembling)
1. Check the direction of the groove (3).
2. Install the valve plates (2) to the anchor pins (4) securely.
3. Install the groove of the valve plate (pump plate) to the engine
side.
(1) Center Section
(2) Valve Plate
2-S25
TRANSAXLE
18 to 20 N·m
1.8 to 2.1 kgf·m
13 to 15 lbf·ft
18 to 20 N·m
1.8 to 2.1 kgf·m
13 to 15 lbf·ft
(4) Internal Cir-clip
(5) Oil Seal
(6) Center Section
W1086612
(3) Groove
(4) Anchor Pin
W1086956
KiSC issued 06, 2009 A