Table of Contents
Advertisement
General
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
techsupport@woodstockint.com.
Calibrating.Table.Tilt
The table tilt lock knob and tilt scale are used to tilt the
table for horizontal angle cuts.
Note: The table tilt scale is only an approximate scale
and should not be used when precise angle measurements
are required for the operation.
Item(s).Needed.
Phillips Screwdriver #2 .........................................1
Wrench 10mm ...................................................1
Machinist's Square 2" ...........................................1
To.calibrate.table.tilt,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Raise hold-down shoe to maximum height and lock it
in place.
3. Loosen table tilt lock knob (see.Figure.35).
4. Place machinist's square behind blade, as shown in
Figure.36.
5. Adjust table to be square with blade, then tighten
lock knob.
6. Loosen pointer screw, adjust tip to 0° mark on scale,
then tighten screw to secure setting.
Model W1872 (For Machines Mfd. Since 04/19)
SERVICE
MAKE. SURE. that. your. machine. is.
unplugged. during. all. service. proce-
dures!. If. this. warning. is. ignored,. seri-
ous.personal.injury.may.occur.
Qty
Table Tilt Lock Knob
Figure.35. Components for calibrating
Machinist's
-30-
Pointer Screw
table tilt.
Square
Figure.36. Squaring table to blade.
Pointer
Blade
Advertisement
Table of Contents
