Gas Supply Connection - Jøtul GF 100 DV II Installation And Operation Instructions Manual

Orifice
Figure 20.
Pilot orifice removal and replacement.
Apply small
label
Figure 21. Regulator Assembly.
Pilot Head
Burner
Plate
Figure 22.
Check burner plate / pilot head alignment. Burner is
secure, and level. The pilot head protrudes above the
burner surface.
Pilot Head
Retainer
Clip
Pilot Base
Gasket
Regulator
Tower
Mounting
Screws

Gas Supply Connection

NO NOT T T T T E: E: E: E: E: If If If If If the optional Blo NO the optional Blo the optional Blo the optional Blow w w w w er will be installed,
NO NO the optional Blo
90 90 90° Elbo ° Elbo ° Elbow o ° Elbo w o w of f f f f f f f f f the v w o the v the valv the v alv alve e e e e t t t t t o cr alv
90 90 ° Elbo w o the v alv
f f f f f or or or or or the main g the main g the main g the main gas line the main g as line as line as line as line. . . . .
The gas supply line connection is made to the valve just
inside the left rear leg. The gas supply line should be 3/8"
npt with a 1/2" diameter supply, or the appropriate size to
provide sufficient gas pressure to the valve regardless of
the input setting.
The use of a Flexible Gas Appliance Connector is
acceptable in many areas in the U.S. However, Canadian
methods vary depending on local code.
ALL INSTALLATIONS MUST COMPLY WITH LOCAL CODE
OR IN THE ABSENCE OF LOCAL CODE, MUST COMPLY
WITH THE MOST RECENT EDITION OF THE NATIONAL
FUEL GAS CODE ANSI Z223.1/NFPA 54 OR CAN-B149.
All codes require a gas shut-off valve (gas cock) and
union, to be installed in the supply line, and in the same
room as the appliance. This allows for the disconnection
of the stove for servicing and maintenance. See fig. 23.
A T-HANDLE GAS COCK IS REQUIRED IN
MASSACHUSETTS TO COMPLY WITH CODE 248CMR.
Secure all joints tightly using appropriate tools and
sealing compounds. For propane units be sure to use
compounds that are propane resistant. Turn on gas supply
and test for gas leaks using a soapy water solution. Never
use an open flame to check for leaks.
Leak test:
1. Use an electronic gas detector, or mix a 50-50 solution of
water and dish soap.
2. Light appliance- see lighting instructions on the inside
back cover of this manual or on the stove's rating plate.
3. Brush or spray all joints and connections with the soapy
water solution.
4. If bubbles appear at any connection or seam or a gas
odor is detected, immediately turn gas control knob to
the OFF position.
5. Tighten or reconnect the leaking joint and retest for any
gas leaks.
Figure 23.
Supply
valve
coupling.
er will be installed, er will be installed, use a er will be installed, use a use a use a
er will be installed, use a
o cr o crea o cr eate adequa ea ea te adequa te adequate clear te adequa te clear te clearanc te clear ance e e e e anc anc
o cr ea te adequa te clear anc
17