Thermal Dynamics CUTSKILL C-100A Operation Manual page 27

2. Poor Work Lead connection.
a. Check the connection of the Work Lead to the
work piece.
Work Cable
And Clamp
Art # A-04389
3. Current sensor or PWM PCB faulty.
a. Return to an authorized service center for re-
pair.
F. Air flows continuously and torch latch switch
doesn't work properly.
1. Torch Latch Switch on front panel faulty.
a. Return to an authorized service center for re-
pair.
2. Control PCB faulty.
a. Return to an authorized service center for re-
pair.
Manual 0-4686
Make a clean work cable
connection to the work-
piece or cutting table
5-3 SERVICE