Paradyne 6512 Installation Instructions Manual page 12

Connecting a 2-Line Phone (with Existing Phone
and One or Two Superlines)
Hardware Required (Supplied)
H
6-foot RJ11 phone cable.
Hardware Required (Not Supplied)
H
Two additional RJ11 phone cables to connect Lines 1 and 2 of your 2-line phone to
your adapter.
"
Procedure
Use the following procedure and supporting figure to connect your SuperLine Adapter
to a single phone with two lines. This configuration can be used if you have one or two
additional phone lines through your SuperLine Adapter.
Line 1:
¶
Plug one end of the 6-foot phone cable into the LINE jack on the adapter rear
panel.
·
Insert the other end of the phone cable into the wall jack.
¸
Connect Line 1 of your 2-line phone into the BASE PHONE jack on the adapter
rear panel.
Line 2:
¹
Connect Line 2 of the 2-line phone into the PHONE 1/2 jack on the rear of the
adapter.
NOTE:
If you use the PHONE 2 jack, do not use a 4-wire phone cable to connect phones,
fax machines, or modems to the PHONE 1/2 jack. A 4-wire phone cable connected
to the PHONE 1/2 jack may cause interference on phones, fax machines, or
modems connected to the PHONE 2 jack.
Second Phone, Fax Machine, Modem, or Line 3:
º
If you have purchased two superlines, you can connect a second phone, fax
machine, modem, or Line 3 of a 3-line phone into the PHONE 2 jack on the
adapter rear panel.
To complete your SuperLine Adapter installation, refer to Connecting Phone Filters to
Your Existing Phones on page 21, and Applying Power to the Unit on page 22.
12