Paradyne 6512 Installation Instructions Manual page 14

Connecting a 2-Line Phone (with Two Superlines)
Hardware Required (Supplied)
H
6-foot RJ11 phone cable.
Hardware Required (Not Supplied)
H
A 2-line phone cable (RJ14C) to connect Lines 1 and 2 of your 2-line phone to your
SuperLine Adapter. Refer to Technical Information on page 23 for RJ14C phone
cable pin configuration.
"
Procedure
Use the following procedure and supporting figure to connect your SuperLine Adapter
to a single phone with two lines.
NOTE:
Use this configuration only if you have two additional phone lines through your
SuperLine Adapter.
Lines 1 and 2:
¶
Plug one end of the 6-foot phone cable into the LINE jack on the adapter rear
panel.
·
Insert the other end of the cable into the wall jack.
¸
Connect your 2-line phone using the 2-line RJ14C phone cable to the PHONE 1/2
jack on the adapter rear panel. The 2-line phone cable connects both lines through
the PHONE 1/2 jack.
NOTE:
The PHONE 2 jack cannot be used to connect additional phones, fax machines, or
modems in this configuration.
Existing Phone, Fax Machine, or Modem:
¹
Connect your existing phone, fax machine, or modem to the BASE PHONE jack on
the adapter rear panel.
NOTE:
If you lose power to your SuperLine Adapter, the phone connected to the BASE
PHONE jack will still be operational.
To complete your SuperLine Adapter installation, refer to Connecting Phone Filters to
Your Existing Phones on page 21, and Applying Power to the Unit on page 22.
14