Transmission - Minolta Di250f Operator's Manual

14-20
4. Troubleshooting

Transmission

Condition
The document is not
scanned.
The document is
scanned diagonally.
The image received at
the destination is
unclear.
A blank sheet is printed
out at the destination.
Automatic transmission
is impossible.
TX Marker is too faint.
Cause
The document is too thick.
The document is too thin or
too small.
Document scanning area is
dirty.
The document guide plate is
not adjusted to the document
width.
The document is not set
correctly.
The document scanning area
is dirty.
The text on the original
document is too faint.
There is a problem with the
condition of the line or the
facsimile at the destination.
The document was set face
down (when the automatic
document feeder was used).
The number is wrong.
Calling a number dedicated to
telephone use.
There is a problem at the
destination (such as running
out of paper, the setting unable
to use automatic reception
mode or power turned off).
The Marker is running out.
Countermeasures
Use the book scanner for
transmission.
Use the book scanner for
transmission.
Clean the document scanning
area.
Adjust the document guide
plate to the document width.
Set the document correctly.
Clean the document scanning
area.
Adjust the contrast for
scanning.
Check by using this machine to
make a copy. If the copied
image is clear, try sending it
again.
Set the document face up and
try resending it.
Reconfirm the number.
Reconfirm the number.
Contact the destination.
Replace the TX Marker.
Reference
page
3-3
3-3
13-16
1-20
1-20
13-16
3-12
-
1-20
-
-
-
13-11