Minolta Di250f Operator's Manual page 288

13-10
2. Replacing the Imaging Unit and Toner Bottle
Replacing the Toner Bottle
Pull the cover of the toner bottle housing area
1
open.
Slowly pull out the toner bottle.
2
The new bottle of toner should be gently
3
tapped four or five times at each end (top and
bottom) on a desk or table.
NOTE
The toner may have settled, so it should be well
loosened.
Shake the new toner bottle well.
4
NOTE
Turn it upside down about 5 times.
5
NOTE
2$%
It should be removed slowly to prevent the toner
from spilling out.
6
2$$
NOTE
Insert the toner bottle up to the black line.
7
2$$
NOTES
• It may be impossible to remove the toner
• The toner is automatically supplied to the unit
2 $$
Carefully remove the seal on the toner bottle
with the seal facing upwards.
The "UP" mark on the toner bottle should be
facing upwards when it is being installed.
Close the cover.
bottle if the cover is opened while the toner
bottle is turning. In this case, close the cover
and try again a short while later.
after the cover of the toner bottle housing is
closed. Do not turn the power off, or open the
cover while the toner is being supplied.
Seal
2$$
2$$
2$$