Table of Contents
Advertisement
USING THE CHARGER
The charger should be examined regularly for damage to the cord, plug, enclosure
and other parts. In the event such damage has occurred, the electric dirt bike
should not be charged until the charger has been repaired by qualified personnel or
replaced.
Use only the supplied, recommended charger.
• Always use caution when charging.
• The charger is not a toy and should be operated by an adult.
• Never operate the charger near flammable materials or liquids, and operate the
charger in well-ventilated areas.
• Disconnect the charger and unplug it from the electric dirt bike when not in use.
• Do not exceed the recommended charging time.
• Always disconnect the charger from the electric dirt bike prior to wiping down or
cleaning the electric dirt bike with any liquid.
FAILURE TO HEED THE WARNINGS LISTED ABOVE INCREASES RISK OF POTEN-
TIALLY SERIOUS INJURY. USE THE APPROPRIATE CAUTION WHEN RIDING AND
ALWAYS WEAR PROTECTIVE GEAR.
BEFORE YOU BEGIN ASSEMBLY
WARNING:
Remove all packing and items from the display box. Make sure that the power switch
is turned "OFF" before assembling the electric dirt bike.
ESTIMATED ASSEMBLY TIME
You should allow approximately 20 minutes for assembly, not including initial
charging time. Initial charging can take approximately 18 hours (see page 11 for
charging information).
Remove contents from box. Remove all the separators that protect the components
from damage during shipping. Inspect the contents of the box for scratches in the
paint, dents or kinked cables that may have occurred during shipping.
MAKE SURE POWER SWITCH IS TURNED "OFF" BEFORE CONDUCTING ANY
MAINTENANCE PROCEDURES.
Assembly by adult with mechanical experience is strongly recommended.
WARNING: DO NOT USE NON-ORIGINAL OR
NON-RECOMMENDED PRODUCTS WITH YOUR
ELECTRIC DIRT BIKE.
use of non- recommended replacement parts may or may not be compatible
with the design and will void the warranty and may cause an unsafe condi-
tion resulting in serious injury or death.
WARNING:
Be careful not to touch the motor after use as the motor may become hot with use
and touching it after use could result in risk of burns or other injury.
Altering of the original components or the
7
Advertisement
Table of Contents
