Table of Contents
Advertisement
Problem
Electric dirt bike runs sluggishly
Sometimes the electric dirt bike
doesn't run, but other times it does
Electric dirt bike makes loud noises
or grinding sounds
Charger unable to plug into the
electric dirt bike charging port
Possible Cause
Riding conditions are too severe
Tires are not properly inflated
Product is overloaded
Brakes are not adjusted properly
Loose wires or connector
Motor or electrical switch damage
Chain is too dry
Solution
Use only on solid, flat, clean and dry
surfaces such as pavement or level
ground.
The tires are inflated when shipped
but they invariably will lose some
pressure between the point of
manufacturing and your purchase.
Refer to instructions on page 12.
Make sure you do not overload the
product by allowing more than one
rider at one time, exceeding the 140
lb. maximum weight limit, going up
a hill or towing objects behind the
product.
Adjust the brakes pursuant to the
instructions on page 16.
Check all wires around the motors
and all connectors to make sure they
are tight.
Replace with a new motor or
electrical switch. Visit the Dynacraft
website: www.dynacraftbike.com
Apply a lubricant such as 3 in 1
Tri-Flow
to the chain.
™
Check to see if there is any dust
or debris. If there is, gently draw
the debris out with small stick. (Do
not use needles or any other metal
objects to remove debris, as this
could lead to a short circuit.)
or
™
23
Advertisement
Table of Contents
