Detailed Maintenance And Repair - Dynacraft 8802-33 Owner's Manual

DETAILED MAINTENANCE & REPAIR
WARNING: Turn the power switch "OFF" before
conducting any maintenance procedures.
Testing the Brakes
To use the brake, squeeze the lever to increase the pressure on the brake. The brake
lever is fitted with a cable adjuster to compensate for cable stretch and/or to fine-
tune the lever movement to brake engagement. If brake is not engaging properly,
follow instructions for adjusting the brakes.
Adjusting the Brakes
2. If the brake cable is still either too tight or too loose, use a 10mm wrench to loosen
the brake cable pinch bolt for further adjustment on the cable. Ensure that the 10mm
16
Tools required; 10mm wrench
1. To adjust the brake cable tension,
turn the adjusting barrel on the
brake lever clockwise (to loosen)
or counter-clockwise (to tighten).
Only turn the adjusting barrel in
small increments until the desired
adjustment is reached. If the brake
continues to need adjustment,
proceed to the next step.
Note: Keep brakes properly adjusted
and in good working condition at all
times. Check to make sure that the
brakes are functioning properly after
any adjustment and before riding.
nut is securely tightened after
the adjustment is made.
Note: The brake lever contains
a safety switch to cut power
to the motor when the brake
is applied. In an emergency,
applying the brake will always
stop the product from moving.
Do not disable or replace this
lever with anything other than
a genuine original replacement
part.