Dynacraft 8802-33 Owner's Manual page 21

4. Repeat the steps above in reverse and securely tighten all bolts before finishing.
Note hardware sequence as shown above:
Left Side
D–Rear brake cover
B–Washer
A–15mm locknut
20
Middle
E–Rear wheel set
(with chain wheel on)
9. Re-attach the chain guard.
Test ride and readjust as needed.
Chain Tensioner
Replacement
Note: Use a Phillips screwdriver to
remove the 3 bolts from the chain
guard.
1. Lift the chain tensioner arm up.
2. Use the Phillips screwdriver to
loosen (counter-clockwise) the
bolt on the chain tensioner.
3. Pull out the worn chain
tensioner and replace it with a
new one.
Right Side (Throttle Side)
C–(Long) spacer
B– Washer
A–15mm locknut