7. If you have other options to install or remove, do so now.
8. Replace the support-bracket assembly and reconnect the fan cable to the
9. Reinstall the side cover. See "Installing the cover" on page 50.
10. Reconnect the external cables and power cords; then, turn on the peripheral
Installing a security U-bolt
To help prevent hardware theft, you can add a security U-bolt and cable to your server.
After you add the security cable, make sure that it does not interfere with other cables
that are connected to the server.
Before you begin:
•
d. Locate the tab on the rear of the microprocessor socket (the side facing the
power supply). Then, press down and latch the retainer onto the tab.
e. If you have installed a fan sink, connect the fan-sink power cable to the
microprocessor fan-sink connector (CPUFA1) on the system board. See
"System board internal cable connectors" on page 24 for the location of the
microprocessor fan-sink connector.
Note: Make sure the cable is not in a position to interfere with the fan sink
operation.
connector (SYSFA3) on the system board. See "Removing the support-bracket
assembly" on page 34 for details. See "System board internal cable connectors"
on page 24 for the location of the fan cable connector.
devices and the server.
Obtain the following items:
— A flat-blade screwdriver
— An adjustable wrench
Chapter 5. Installing options
49