Removing And Installing A Microprocessor; Removing A Microprocessor - IBM eServer 200 xSeries User Reference Manual

Removing and installing a microprocessor

Your server supports only one microprocessor, which is installed on the system board
in the microprocessor connector (U11).
Notes:
1. Before you install a new microprocessor, review the documentation that comes
2. For a list of supported operating systems, see http://www.ibm.com/pc/compat on
Note: The illustrations in this document might differ slightly from your hardware.

Removing a microprocessor

Your comes with a heat sink or a fan sink installed on the microprocessor, depending
on your server model.
Note: The following illustration shows a heat sink installed on the microprocessor.
46
IBM xSeries 200: User's Reference
with the microprocessor to determine whether you need to update the server
BIOS code. The latest level of the BIOS code for your server is available through
the World Wide Web. Refer to "Getting information, help, and service" on page 91
for the appropriate World Wide Web addresses.
the World Wide Web.
Microprocessor
connector
Microprocessor
Heat sink
Retainer
Microprocessor
orientation indicator
Lever
Tab